Die Cut Polyurethane Domed Labels

Dome stickers 38

Dome stickers 39

Equipment and consumables required of Die Cut Polyurethane Domed Labels:

Basic equipment: Digital display electronic scale, vacuum degassing machine, epoxy platform (glass), plastic cups for mixing glue, stirring rods, plastic glue pots, double-sided adhesive tape.

Cleaning agent: absolute ethanol.

If conditions permit, the following equipment can be added: baking oven, automatic glue dispenser, etc.

The manual operation process of crystal glue Die Cut Polyurethane Domed Labels is as follows:

First, put all kinds of prepared substrates, such as: self-adhesive, PVC, laser material labels, synthetic paper, metal, aluminum sheet, stainless steel, plastic, coated paper, acrylic, into an oven for preheating at 60 degrees to remove moisture on the surface.

Put the dehumidified substrate flat on the glass plate of the operating table with the same level and wait for the glue to be dropped.

According to the dosage, take a clean beaker, measure it accurately, mix components A and B according to the weight ratio of 2:1 and stir evenly (must be mixed evenly, otherwise there will be sticky surface and delamination with the substrate, which is the same for all kinds of products.) (Note: The proportion of the product is not the same, depending on the actual situation).

Different Bases for you to choose