Epoxy Resin Waterproof 3D Car Logo

Custom sizes, colors and contents
Full colour, high resolution digital printing
High quality, flexible but tough dome resin
UV resistant, waterproof, non-yellowing construction
Superior adhesion including a range of metallic look vinyls

Send Inquiry

Product Introduction

Epoxy Resin Waterproof 3D Car Logo

Dome stickers 20

Dome stickers 21

Dome stickers 19

The manual operation process of crystal glue labeling Epoxy Resin Waterproof 3D Car Logo is as follows:

6. 3-5 minutes after instilling crystal glue on the substrate, observe whether there are air bubbles or dust particles on the surface of the glue. If there are small bubbles, use a pin to pierce them.

7. The poured crystal epoxy signboard is cured at room temperature of 20°C-30°C for 10-24 hours to harden, and becomes a crystal signboard that does not stick to the surface.

8. In case of self-adhesive labels, trademarks, etc., the thickness is very thin and the boundary line is not obvious. When pouring, it is easy to cause the crystal glue to overflow. It is difficult to achieve a thickness of 2mm. Therefore, the crystal glue should be grasped according to different situations and the viscosity should be well controlled. During the application process, it can be placed for 1-2 hours to increase the viscosity and adapt to the pouring of thin crystal glue.

9. To make a crystal glue (drop plastic label) sign with a thickness of more than 2mm, it can be divided into two drops of plastic, after the first drop of plastic, cure for 3-5 hours, and then add another layer.

10. Cleaning after plastic dispensing, regardless of manual dispensing or automatic dispensing, the machinery, equipment and containers must be cleaned after completion, because the crystal glue is insoluble in any solvent after hardening, so the machine and the container must be cleaned before it hardens. (Suggestion: use acetone or absolute alcohol)

Different Bases for you to choose