Electroformed Label Thin Nickel Metal Sticker Logo

Electroformed Label Thin Nickel Metal Sticker Logo

How to make nickel sheet Electroformed Label Thin Nickel Metal Sticker Logo?

• Out of the film

1. Film is the transliteration of fim, which is used for printing plate making. In printing, it is called film, film, and film. It is used to make printing plates. In the past, printing was made by arranging type plates, but now the film is produced after it is arranged on the computer. , the printed content is on the film, and then exposed through the drying machine to expose the content on the film to the steel plate.
2. Technological process: Firstly, the CDR drawing is typesetting on the computer with nickel sheets. In the process of typesetting, in order to ensure that the finished product will not fall off when it is taken, the edges of the film paper and the question of each logo will be left. A gap accurate to 3mm is produced to improve the yield rate.

• Development:

1. The operator dips the exposed stainless steel plate into the developer solution, and puts 4-6 pieces each time.
2. The soaking time should not exceed 1 minute. If the time is too long, the ink will fall off easily.
3.  Gently wipe the developing surface with a sponge until it is fully formed.
4. Rinse the surface with clean water, and visually inspect the surface for miscellaneous spots, scratches and missing stars. If the development is not sufficient, it needs to be reworked, and other poor development is directly discarded.

Application

Production Process

Our Sample Room